Dinasaw® Chain Sharpeners

Control Panel Functions

Plug the machine in and pull the isolation switch out to power up the machine.

Power indicator light:

· Indicates that power is on.

Function indicator light:

· When in "Run Mode" light is on.

· When magnet is detected light will go out momentarily.

Detection mode indicator:

· Indicates which mode machine is in.

· "OFF" - No detection. Machine grinds sequentially.

· "AUTO" - Automatically detects double cutters (left or right).

· "MAGNET" - Corrects only after chain magnet passes proximity switch.

Stop / Reset:

· Stops the machine

Start:

· Starts the feed mechanism.

Grinder:

· Turns the grinder motor on - press again stops motor.

Speed Increase / Inch Fwd:

· Increases feed speed in run mode.

· "Inches" machine forward when not in run mode.

Speed Decrease / Inch Rev:

· Decreases feed speed in run mode.

· "Inches" machine in reverse when not in run mode.

Detection Mode:

· Changes between the three detection modes and is shown by the Mode Indicator lights.

Counter:

· Sets number of times chain circuits (maximum of 9)

· Counter is triggered by placing the magnet on chain (Low down on sideplate,on or between the rivets of a cutter).

Counter Display:

· Indicates number of circuits chain will do, referenced by the chain magnet.

 

Holding Counter + Speed Increase:

· Positions the machine for adjusting the top plate angle of LEFT hand cutters.

· Display will show a symbol.

Holding Counter + Speed Decrease:

· Positions the machine for adjusting the top plate angle of RIGHT hand cutters.

· Display will show a symbol.

Back            Next            Exit